Home Page
Your best source for Gaskets, Durlon®, Parker, TFE, PTFE, O-Rings, Molding, Gore-Tex®, Perfluoroelastomers, Graphite, Sponge, Heat Exchangers, Hypalon®, Rubber, Packing, Seals, TFE, J.M. Clipper/Leader®, Rubber, Nitrile, EPDM, Kalrez®, Sealon™, Spiralwounds, Ring Joints, Silicone, Neoprene, Viton®, Flexible Graphite Sheet, Barge Sealing Supplies, Butterworth Gaskets, Marine Gaskets and Seals, Ultralon™, Waterjet Services and More!


Sealon™ Applications



Extreme Chemical Resistance
-350°F to 500°F
Low Cold Flow
Low Torque Requirements
Identifiable Color for Visual Inspection and Safety
Non-Stick
Branding Available
F.D.A. White Available on Request
 Warped or Scored Flange Surfaces Benefit From the Exceptional “Sealability” or “Formability” of Sealon™
Large Diameter Flanges Benefit From the Ease of Bolting and Ease of Installation (1-Piece Construction) of Sealon™.
Standard A.P.I. Flanges Will Seal Easier and Maintenance Personnel Will Find Sealon a Most Forgiving Gasket Material.
Sealon™ For Oxygen Service

Gasket Materials Approved For Oxygen Service
The following materials have been approved for gaseous and liquid oxygen service by the L’Aid Liquid Laboratory at Blane Mesnil:

FAWN GYLON #3502, a product of Garlock®, available in sheet form 1/16" and 1/8" thick.

SEALON™, a product of Ameraflex Sealing Products, Inc. of Deer Park, TX, available in 1/32", 1/16", and 1/8" thick.

GORE-TEX® JOINT SEALANT, a product of W. L. Gore & Assoc.®, Elkton, MD, available as a tape, strip or round extrusion from a little more than 1/32" to 3/4" thick.

Fawn Gylon® #3502 is a fawn colored sheet material that is primarily PTFE that is filled with an inert solid. The #3502 must be specified as it is specially formulated from materials that are suitable for oxygen. They also sell a Fawn Gylon® #3500 that is not to be used with oxygen. It is fairly expensive and is usually only sold by the 5' x 5' sheet.

Sealon™ is also a filled PTFE material with a salmon color, with properties very similar if not the same as Gylon®. It is said to be less expensive than Gylon® and can be bought and cut to size standard pipe gaskets or smaller than the 4' x 4' or 4' x 8' standard sheet.

Gore-Tex® ribbon is 100% PTFE, white in color, and can be used to seal some flanges and for some valve stem or similar packing applications.

The testing lab warns that if any of these materials are to be used where there is likelihood of adiabatic compression with oxygen, additional tests should be conducted under specific conditions before use is approved.

A. R. Potter, BGD Safety Manager

Sealon Home | Applications | Properties | Resistance Charts


Gylon® is a registered trademark of COLTEC Industries.
Gore-Tex® is a registered trademark of W.L. Gore & Associates, Inc.
Sealon Is A Trademark Of Ameraflex Sealing Products Co., Inc.







Ameraflex Sealing Products Co., Inc.
317 Georgia Avenue  •  Deer Park, Texas  77536
1-800-522-7325  •  (281)476-8500  •  FAX(281)476-8520
e-mail


Copyright © by Ameraflex Sealing Products Co., Inc. All Rights Reserved
Another Website